Recent content by 77cruiserguy

  1. 7

    Capped port?

    As always Mud comes through. Thanks. I am very much at sea level. Capped it is
  2. 7

    Capped port?

    Maybe capped is the way to go.
  3. 7

    Capped port?

    Nope. Normal US spec. Odd.
  4. 7

    Capped port?

    Can anyone educate me on where this capped port is supposed to connect? I have an 4/77 40 that still has all the emissions equipment installed. I’m replacing all my vacuum lines and in looking through my manual I realized this port had incorrectly been attached to my TP diaphragm. I’ve...
  5. 7

    Hardtop Clamps

    Anyone had success (or failure) using truck canopy clamps on a 40 hardtop? Replace the bolts and save a little time on removal/install? any specific ones that are recommended?
  6. 7

    77 2f carb adjustments

    Looks like your the man in this particular arena. Got one for my 4/77 40? What’s the best way for me to go about buying?
  7. 7

    77 2f carb adjustments

    I’m 4/77. The idle speed screw being horizontal is what’s really strange to me. It’s cast so there’s no screwing it up on a rebuild. Makes me wonder where this thing came from.
  8. 7

    77 2f carb adjustments

    I think this is approaching a foregone conclusion. I need to get a rebuilt original. Any suggestions on where/who? I need it ASAP!
  9. 7

    77 2f carb adjustments

    Specifically this area from a couple angles would be awesome
  10. 7

    77 2f carb adjustments

    If you could grab a pic of the vacuum assembly for your secondary it would be great. Mine looks to be just slightly stuck open and I think the Spring/linkage is a little wonky. It looks like it’s hitting the heat shield!?!?
  11. 7

    77 2f carb adjustments

    Here she is
  12. 7

    Part identification?

    Makes sense. Thanks!
  13. 7

    77 2f carb adjustments

    Thx. I’ll take a pic of the whole carb later this am. I looked it up on SOR and it’s really close but different linkage and these weird screw placements. my issue is I can’t adjust the rpms because none of the adjustment screws are in contact with their stops. It’s running rich. If I back...
  14. 7

    Part identification?

    Found this laying on top the manifold up towards the fire wall. Metering rod?
Top Bottom