1st of all, you Suck 🤔🧐😘🤣 just kidding. Your Shop is nicer than my house! Me tired of rolling around in dirt n snow to work on things 😤. Please adopt me 😥 I'll behave I promise! I dont eat much, just need 🍻. Only have 3 vehicles, Atv and tractor...
Sad state of affairs. After completing the heat riser gasket replacement I cracked the flange to the exhaust. This is a 1970 pig. I am disappointed and sad.
On Sunday we actually worked on the redneck trailer. Got it completely stripped down and ready for blasting. The only bits left is to take the doors apart. I have to wait a few weeks before I can get back on it, but we are going to weld in some...
Got the Ebrake in.
Got all the door cards cut! Was using mdf and now I m using abs.
My 85 year old Mom helped file down the rough edges. ‘You work for me old lady!’
Naw just kidding. Told her to hurry up though! So great! She told me the...
You'll have to go inside the door and take it all out in order to check what's going on. There's a lot of moving parts in there, but nothing too hard to figure out.
“I hear that 2F a-comin’,
It’s comin’ ‘round the bend,
It ain’t had the valves adjusted since I don’t know when,
Driver’s dropped it into third, foot mashed to the floor,
Eyes watering from exhaust fumes, bound for Pig Party 2024….”
This is kind of like putting the horse before the cart, more like putting the winch before the pig. A couple years ago I picked up an 8274 for the rig. Fellow mudder expressed interest in the winch too, to I found a second to rebuild for him...
Since Steve the pig is in Texas getting 5.3 transplant,,Ornch at body shop, that leaves pumpkin the pig-a 72 that ran when parked 18 months ago, that I was going to part out, but may be my primary pig for awhile
So I will pull out, tomorrow and...
The blue LS swapped pig went to the BAT high bidder (reserve was not met). Apparently the owner and the high bidder were able to find common ground after the auction. I made a post-auction offer on the truck, but the high bidder wanted it more...
Australian ruling when it comes to modified vehicles, and in the state I live in New South Wales it's 10x more hoops to jump through.
So for chassis shortening the cut needs to be plated externally over 250mm either side of the cut, of the same...
Wanted to show you guys what’s been going on over here with the wiring of the engine harness.
I picked up all new connector “kits” from a company called EFI Connection.
https://www.eficonnection.com/
Here’s some pics -
Removed about...
While many of you have seen these photos before, they are pertinent to this thread and some of the newer guys may not have seen them. I'm now thinking this was more like 1990 as the smallest kid was born in January of '88 and I remember the kids...