Edelbrock Gaskacinch, basically a light glue, helps seal paper gaskets, yet applies super thin and easily scrapes off after disassembly years later.
I've often just used a fingernail to peel off years-old Gaskacinch residue.
Keep the lid tight to prevent pre-mature dry-out.
Aren't OEM compression values for when the engine is at operating temp?
Meaning those #s would improve @ operating temps?
If you run it, pls run the comp test again at operating temps to see what increase in compression #s occurs.
And post 'em up. :)
10 55w halogens!!
May I suggest substituting far fewer LED lamps. Most LED lamps draw few amps with superior lumen output compared to similar halogens. Also long lasting. Would help reduce total amp load.
These folks make tough LED lamps: Rigid Industries
An internet search on "off-road...
Agree. Not bad. Wish they didn't use sideways pocket bolt mounting. Too J**p-like.
Any idea what material? Would suck if they just crack when rubbed/bumped.
Will the roller bearings receive adequate oiling in the 2F?
Splash oiling? Pressurized oiling? Any special block machining required?
I imagine the sub 4000 rpm "reasonable, common sense" operating range of the 2F would be less oiling needs than a 6k-plus SBC.
Edit: Nevermind. I just...
I think a shackle reversal stresses the front driveshaft under significant droop when the same droop with OEM front shackle set up doesn't. Jim C explains better:
"shackle-reason
Never heard of it, but I wanted to know what POR-15 offered for a bed coating.
So, I searched POR-15's site to find the link you should of posted :D
j/k :)
Interesting new product. It's called POW-R-LINER.
This statement concerns me:
" POW-R-LINER™ is engineered to be applied on top...
For the rear axle, how 'bout using an Eaton H052 FF axle out of a 67-72 GMC/Chevy truck?
Mounting "hole" for drop out 3rd is already offset to center in the truck the offset pinion. Swap the housing around, stick the 3rd out the back that is now the front and Whalla! Instant offset axle for...
Hmmm...
Could plugged tubes in the rad's core cause enough pressure to blow upper hoses?
If you have access to a temp reader, check for cool spots on the core when eng at operating temp.