the first 2 pics are OEM A/C
originally set up for R12, I like R12 versus R134A
A vacumn needs to be pulled and checked for leaks, we will also charge with nitrogen for a leak test
when the system is charged, there is a low pressure switch if the...
First off, wanted to thank all the Forum contributors for the wealth of knowledge and feedback that is selflessly and endlessly shared here. It is an incredible resource that is invaluable and feel fortunate to find so many like-minded...
within the last few weeks someone posted up replacement for the lower with the sensor holes
here it is:
https://forum.ih8mud.com/threads/2f-thermostat-housing-for-smog-compliant-60s.1335532/
if it is the same as an FJ40 radiator
drain coolant
remove top and bottom hoses
remove bolts that hold the fan shroud to the bracket, these should also hold the radiator to the bracket
move shroud toward engine
radiator should lift out
jack up 1 end of the rear axle, chock front axle, trans in N, transfer in 2H, release park brake, put mark on driveshaft
rotate the tire 1 full revolution and count how many times the driveshaft spins
this will get you close to the ring and...
CM was a blast this year! Great to see everyone, new friends and old. We wheeled. Broke stuff. Fixed stuff. And then wheeled some more. :steer:
After pre-running TOTW:
406 Cruiser Row at the Arena. (But I didn't get Nick and Ashley in this...
After 4 years of a few failed attempts! Finally got these reproduced.
I've had them made exactly as per original specification ( molded) out of EPDM Rubber.
it is labor intensive, and most shops don't want to do the work.
maybe cross the border and have it done down there
find an old school guy who is willing to take the job on
learn how to do your own metal work
without pics, it is hard to guess...
Ok, we will try it again …..
1969 rear Barn (half) Doors, complete with hinges latch, catch and floor barrel bolt. They were blasted, now flash rusted. They will clean up real well with another bead blast, no rust through, not bent.
$500.00...
I only wish this rig had some spare parts. 🤣
This tank drives like a dream. Pulled my back loading stuff and decided I don’t want to quit hurting now so I’m unloading.
Mark I can’t thank you enough. My whole family is excited about it.
What a week! Lot of great trail rides, had a chance to stare at the back of a lot of different trucks, including a couple of familiar ones.
Fun times with 406 club mates and a bunch of new friends.