Quick lap to the property with the littles! Hard to resist snapping a few pics!
Few things in the works for the exterior rear of the canopy. Rear amber facing work light as well as some internal canopy door lights. Jerry can holder and 5lb...
As my close buddies know, I can't leave well enough alone. So I've continued to mess with my pump settings, seeking the holy grail of parameters that allow me to climb a hill with reasonable EGT's, start with no smoke, all the while not rattling...
Been a few busy last weeks with getting my 84 pickup back on the road.
Finished rebuilding my 22R and installed it. Thankfully I had a spare motor that needed rebuilding since the one I pulled out was in real poor shape after I overheated it on...
Nothing major today I relocated the espar fuel pump closer to the other side now need to get a T to make a junction between the fuel tank and wabasto cooker. Also thinking about an actual hermétic way to get fuel out don’t like the plastic line...
Recently added a few mods to make the 79 a bit more convenient for getting away for a few nights. With a 3-year-old and a 10-month-old I have really struggled with the sleeping situation. I have always wanted a RTT but it needed to accommodate...
The last few days has been building out FTE swap harness.
Unichip with OEM Toyota plugs so it can simply be removed or installed by plugging in these two plugs.
ECU wiring.
Love this wire we found for projects like this. Everything...
Well, after two years of sitting outside I brought my truck into the shop and my plan is to start ramping up on finishing my engine swap.
My goal is to drive it out to Rubithon this year…. Crossing fingers…
Took a break from the 60 and took the Kawasaki Jet Mate to Mallacoota for a weekend.
It went awesome. I thought i was in some trouble for a bit coz it wouldn't get up on plane. We'd been drinking at the pub for a few hours and still had to get it...
Hello everyone,
I just installed the controller into my 1984 bj42 24v Canadian spec.
Installation is very straightforward and all literature provided is very concise and accurate. The factory harness connection needs to be swapped as they are...
Sooooo
After my last tests I made a 3rd version of my superglow electronic replacement.
I fixed all identified hardware bugs and made global improvements (stability, power supply variations,...). I added a wilson switch port that does not need...
Well I'm home for spring break for the next 10 days or so, thus I have access to a garage and welder! Well my quarter panels have had rust popping up on them for the past 2-3 years now, I grind it down, convert it, paint it, and it returns in a...
Hello,
Chance's indicators began to act erratically.
I checked for bad grounds, and found a stripped wire. The pervasive legacy of alarm installers. I repaired it, but the problem persisted. The combination switch is fine, and the rest of...
This time I put the transmission into first gear so I can wiggle the rear output to wiggle the input shaft to fit into the splines on the clutch and into the pilot bearing. Tomorrow should be done with putting everything back together and fill...