Dunkane

no source for a correct panel with upper side channel ? :rolleyes:

hello where to find a right rear side panel with upper chanel for a 1964 fj40 ? (same until 1969) complete side panel even without the round gas filler. best regards

can you give me somes measures ? of the rear on your ? thank you

ok i found why, 5 mm difference because the guy who made took the model on a bj42 and seems it was yet repaired so maybe here is the mistake for me too check..

Talk about Unicorns. Might check with @ToyotaMatt

i have exactly the same issue with a new rear sill and new quarter panel on my 64 fj40....a gap of 5 mm , so maybe there is a shape difference between the new quarter panel coming from my donor, bj40 1980, and the 64 fj40.... i measured on a RHD...

hello, Where to have complete new 1964 fj40 ignition switch+ doors matching ? (same key for doors and start) best regards

try asking www.lrc.eu about thoses parts. luc and robbie are nice guys !

hello , are somes of you can give me measure from floor to end of rear sill , to compare with a 1980 fj40 or bj42... seems there are somes differences i need measures in yellow thank you

their tickness is 1.2 mm...18 gauge...mesured on their part by a friend who import somes of their parts...

Success....

Done yet .

Hello How to remove this After removed screws ? (I am changing side panel )

thank you, blue one on my post was one of Proffitt cruiser, have been modified :), he just said me this by mail :) thank you for your help

That blue one is interesting. Here are five of my tubs. The early soft top tub is a 62. I have two hard top models made in 61 which is the same. Not quite sure when the high B pillar ended during 1963. The blue you posted guessing is mid 63 to...

ok this guy sell juncheng steel like this one

ok but i just want to know about the wheel shape panel .... seems there are somes differences ;)

wich is good ?

hello . nobody ? :)

hello, is there a difference between 1964 rear quarter panel and 1975 ? is this demi aile arrière gauche pour toyota land cruiser série 4 – Garage 4X4 Balleydier - https://balleydier4x4.com/shop/pieces-detachees/piece-detachee-5254/ will fit to...

hello looking for an oem owner manual or repro if there is no in stock :) , fj40 1964 (december 63 model) thank you

After deep testing on bench and in car I can proudly say that my electronic superglow works great ! Here is a picture of the final board inside the timing box: The card in detail: I switched to transistors for increased robustness. I also...