I built some 30mm front coil spacers for the 80.
Cost: A few hours.
Used some 1/4" flat plate and a piece of old axle tubing that I had laying around.
Cleaned the tube up then cut to size.
Made a template and cut the plates out.
Drilled holes for the bottom plates.
Drilled and taped for the top plates.
Ready to be welded and painted.
Cost: A few hours.
Used some 1/4" flat plate and a piece of old axle tubing that I had laying around.
Cleaned the tube up then cut to size.
Made a template and cut the plates out.
Drilled holes for the bottom plates.
Drilled and taped for the top plates.
Ready to be welded and painted.