I was trying to fire my Cruiser up last night after the full buildup. Ran before I did the buildup. Tried to start it to get it in the garage, but wasn't getting fuel. Thought bad fuel pump. Pushed it in. did build-up.
Put on a new pump during the build. New filter. Glass canister. new lines.
I blew through the lines from the filter and all is good. Put some fuel in the filter. cracked lines. whole nine and nothing at the carb.
This is on a 71' engine so no spacer issues. It is the aftermarket pump from CCOT. I have not taken it off of the engine yet, but I am sure it will pump fine when I do. If that is the case what is there to do to fix the issue.
I know someone else had that problem on here once where it is fine off engine but once on nothing. How would you go about getting it to ride on the lobes better to pump? Going to get it figured out this evening when I get home
Thanks, Mike
Put on a new pump during the build. New filter. Glass canister. new lines.
I blew through the lines from the filter and all is good. Put some fuel in the filter. cracked lines. whole nine and nothing at the carb.
This is on a 71' engine so no spacer issues. It is the aftermarket pump from CCOT. I have not taken it off of the engine yet, but I am sure it will pump fine when I do. If that is the case what is there to do to fix the issue.
I know someone else had that problem on here once where it is fine off engine but once on nothing. How would you go about getting it to ride on the lobes better to pump? Going to get it figured out this evening when I get home
Thanks, Mike