Hopefully someone has an easy solution for me. I have an 84 FJ60 with a Man-A-Fre 42 gallon gas tank. I just bought the truck so I do not have much history on it.
This is my problem. I tested the gauge like the Toyota manual says to do with a bulb and it moves up and down fine. I also tested the ohm reading from the sender, that at the time was reading 28 ohms. So I no that both work but when I turn the truck on the gauge stays at zero. Acording to the manual the gauge should read about 3/4 full with 28ohms resistance with a factory tank. I did all the checking at the plug in the rear panel before it goes through the body so I know all of the wires are good both ways.
Any help would be much abliged. I have put about 22 gallons in it and god knows how much was allrady in there.
Thanks
This is my problem. I tested the gauge like the Toyota manual says to do with a bulb and it moves up and down fine. I also tested the ohm reading from the sender, that at the time was reading 28 ohms. So I no that both work but when I turn the truck on the gauge stays at zero. Acording to the manual the gauge should read about 3/4 full with 28ohms resistance with a factory tank. I did all the checking at the plug in the rear panel before it goes through the body so I know all of the wires are good both ways.
Any help would be much abliged. I have put about 22 gallons in it and god knows how much was allrady in there.
Thanks