Hello Everyone!
I recently purchased my 2nd FJ40. First was a ‘69 that was sold years ago. Just added a ‘76 FJ40 that sat in the neighborhood behind me for 10+ years without moving. After about 3-4 hours I drove her home and cleaned her up. They started getting panels ordered to complete the rust repair. Getting ready to cut out the wheel wells and then put her all back together but want to double check the hole to hole distance, on the rear side upper rails that the top bolts too, so that I can ensure the correct width. I believe the hole to hole center should be 60 7/8”. Can anyone confirm?
I recently purchased my 2nd FJ40. First was a ‘69 that was sold years ago. Just added a ‘76 FJ40 that sat in the neighborhood behind me for 10+ years without moving. After about 3-4 hours I drove her home and cleaned her up. They started getting panels ordered to complete the rust repair. Getting ready to cut out the wheel wells and then put her all back together but want to double check the hole to hole distance, on the rear side upper rails that the top bolts too, so that I can ensure the correct width. I believe the hole to hole center should be 60 7/8”. Can anyone confirm?