Hey guys, did a quick search but can't find what I'm looking for. I've been working on the 80 (1997) off and on for about a week. Took the entire exhaust out except for the manifolds. Went back with Magnaflow y-pipe and second cat, cheap but correctly fitting muffler, and now I'm fabing up a new tailpipe. Was going to just grab a Toyota one but had a hard time finding them and $300+ for that part seemed stupid when I have tools, including a welder. So, the hiccup I'm running into is how does one install a tailpipe with that ginormous Toyota flange that mates to the rear of the muffler section? I have the first few pieces tacked up with the flange on and I can barely finagle the thing over the frame from the back. If I finish it, there's not a snowball's chance in hades that I can get it to go in....thoughts? I was thinking of making the section that passes over the frame really short and adding another flange connection. Not what I want but the only way I can figure getting it to fit. Thoughts? And how in the heck does an OEM tailpipe get installed? Mine had been modified to be shorter and I used a sawzall to remove it because I was gonna trash it anyway and I didn't think snaking the new one in was going to be as difficult as it has proved to be.