Hey, I believe my rig is leaking a bit of oil where the distributor goes into the block. It's just metal on metal. Is there no gasket for this part?
Thanks
Thanks
Is there a gasket for the distributor shaft? (1 Viewer)
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
1911
chupacabra
Should be an o-ring on the shaft. Are you sure that it's not coming from the tin pushrod gallery cover (commonly called the "side cover") behind the distributor?
Or the oil plug galley, My First Galley Plug Fix - https://forum.ih8mud.com/threads/my-first-galley-plug-fix.351460/
OP signature indicates 5/73 build. If he's got the original F engine, there's no plug, but the original copper tube.
1970 not sure how much yours differs...make sure it seats all the way down or your oil wont pump....
X10,000
If it’s not pumping oil it’ll cost you dearly… likely the engine.
If it’s not pumping oil it’ll cost you dearly… likely the engine.
- Thread starter
- #7
Pretty sure. I torqued it to spec and sealed it really well when I installed it. But it's probably worth some further investigation.
- Thread starter
- #8
It is the original.
- Thread starter
- #9
Mines got an aftermarket electronic ignition unit...
Post #9 after 4 months to get pertinent details.. 
Pics of your electronic doo-hickey....
- Thread starter
- #12
Its a generic one like this...
DELUXE HEI Distributor for Land Cruiser FJ40 FJ60 1F 2F – JT Outfitters
www.jtoutfitters.com
So, @mrjordann , the link you posted above leads to the picture below.
If your distributor looks like this, then you likely have answered your own question.
@
If your distributor looks like this, then you likely have answered your own question.
@
- Thread starter
- #14
How come? You saying it's just bound to leak because it's crummy aftermarket part?
