Hi-Lux FSM good for FJ60 (knuckle job)? (1 Viewer)

[Zack1978]

Hi everyone,
Quick question, I came across my Hi-Lux FSM and I was reading the section about completing a front knuckle job.
Are the torque values and procedures listed in this FSM exactly the same for the FJ60 ? Is anything different about doing the job on a truck vs the 60?
I “think” I’m going to try doing a knuckle job on my 1987 and this FSM could be useful.

Thank you!

 

[3_puppies]

hi lux solid front axle, I would think would be the same as a landcruiser solid front axle
only difference might be the rotor being solid versus vented.

 

[OSS]

Why not use the Toyota 60 manual? I have attached the extracted Front Axle section here.
I bet the Hilux manual is very similar, but maybe there’s a slight difference somewhere.

 

[Zack1978]

Why not use the Toyota 60 manual? I have attached the extracted Front Axle section here.
I bet the Hilux manual is very similar, but maybe there’s a slight difference somewhere.

Thank you!!