My center diff is not working when I put the truck in low. It was just working The CDL only works when the switch is activated and engages quickly.
I searched the threads and performed the following based on what was recommended, but no luck. [The link to the FAQ on Slee is dead]
-- I exercised the H-L shifter about 25x and still no light or click from the kick board.
-- I tapped the T-Case with a hammer, no luck.
-- I tapped the actuator gently with a wrench around it.
-- I put the truck in low and drove around making figure eights on a dirt road.
I haven't jumped the actuator switch circuit yet. Question is, since the CDL locks when the switch is activated, does this mean the actuator is OK and I don't need to jump it?
Thank you in advance I always appreciate the help. I know this topic has been beaten down, but I think I'm missing something before I purchase a new actuator.
Dan
I searched the threads and performed the following based on what was recommended, but no luck. [The link to the FAQ on Slee is dead]
-- I exercised the H-L shifter about 25x and still no light or click from the kick board.
-- I tapped the T-Case with a hammer, no luck.
-- I tapped the actuator gently with a wrench around it.
-- I put the truck in low and drove around making figure eights on a dirt road.
I haven't jumped the actuator switch circuit yet. Question is, since the CDL locks when the switch is activated, does this mean the actuator is OK and I don't need to jump it?
Thank you in advance I always appreciate the help. I know this topic has been beaten down, but I think I'm missing something before I purchase a new actuator.
Dan