kelly saad
Supporting Vendor
The project:
1. Disassemble vehicle, remove doors, tailgate and hatch.
2. Strip paint to bare metal.
3. Replace both fenders.
4. Close all holes in rocker panels from trim.
5. Remove seam sealer in roof gutters, and windshield area, repair any rust, seal again.
6. New lower door skin replacement panels. Sand blast remaining rust, seal bare metal and new seam sealer.
7. New quarter panels and any rusted sections of inner fenders.
8. New doglegs and rear section of rockers.
9. Replace A pillar gutter sections.
10. Exterior paint, B/C, wet sand, and polish.
1. Disassemble vehicle, remove doors, tailgate and hatch.
2. Strip paint to bare metal.
3. Replace both fenders.
4. Close all holes in rocker panels from trim.
5. Remove seam sealer in roof gutters, and windshield area, repair any rust, seal again.
6. New lower door skin replacement panels. Sand blast remaining rust, seal bare metal and new seam sealer.
7. New quarter panels and any rusted sections of inner fenders.
8. New doglegs and rear section of rockers.
9. Replace A pillar gutter sections.
10. Exterior paint, B/C, wet sand, and polish.