The left side locker, the piece that splines onto the axle is up inside, unlike the right hand locker?
SOLD Sears Selectro Dualmatic Course Spline Hubs - San Diego (1 Viewer)
- Thread starter bmoonhajjar
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
bmoonhajjar
GOLD Star
- Thread starter
- #22
Pretty sure my Sears lockers would work from what I see. It is interesting to see the one with a single ring of set screws. Never seen one like that.
I agree. Everything I’ve found shows the early lockers fitting from ‘58 to 9/75. I just do not understand why I have a short locker on one side and a taller one on the other. Let me check measurements and see if I can swap sides with the tall one.
It works! Do you still have them? I’m still not sure how the short one works, I’ll check into it later.
Should have replied to your post instead of mine.
bmoonhajjar
GOLD Star
- Thread starter
- #26
I still got them. Waiting on seals though. Should arrive next week. Do you think you want them?
Last edited:
Yes. The Mrs. is getting them for me for Christmas! As long as they are available.
bmoonhajjar
GOLD Star
- Thread starter
- #28
Nice gift. Yes they are. Let me get the new rubber gaskets in and make sure they fit correctly and then they are yours.
Sounds good. Thank you.
MOTOV8R
SILVER Star
Make sure you act surprised when you open them on Christmas morning.
bmoonhajjar
GOLD Star
- Thread starter
- #31
Ok. Sent you a PM. They are ready to go...
bmoonhajjar
GOLD Star
- Thread starter
- #32
Sold!!!
