x (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Fair enough on the wording... I was hoping someone who is more "artistic" would see a good, clean way to do it. My mockup with tape just isn't inspiring me :/

Maybe integrate the look of the side wings from 4x4labs 80/100 series rear bumper?
 
I ran it around like this.
1.jpg


tail.jpg
 
Are to trying to keep all 4 doors on the pig? I think that front fender outline would look good but the location of the door and fender well create a conflict. If you had a panel over the door you could raise the fender well inside to fit the front fender pattern.

Looks like you put some work into the leaf suspension already but if you linked the rear axle you could move it back a little more and maybe save the 2nd row doors. The rear of the fender well might be pretty open as it exits the rear of the body.

Seems like a can of worms. Good luck.
 

Users who are viewing this thread

Back
Top Bottom