So the clip is at the front of the input gear? The OD slides back about a half inch before the PTO spacer hits the casing. It's tight but I might try freeing the c clip with a flathead, then slide the input gear, pto gear spacer out the PTO access port.
Living in the past, I'm going to send this to either a local machine shop or Mark for estimated condition and repair. Depending on price of remachining lower half (debating 5 speed) I'll keep or scrap. If I scrap it the studs are all yours, you've been super helpful and I appreciate it.
Living in the past, I'm going to send this to either a local machine shop or Mark for estimated condition and repair. Depending on price of remachining lower half (debating 5 speed) I'll keep or scrap. If I scrap it the studs are all yours, you've been super helpful and I appreciate it.