kelly saad
Supporting Vendor
This vehicle is having the motor rebuilt now, so they better not scratch the paint when they install it or should it be this ??
This will be the original color also, I am excited to spray this brown color in new modern paint, wet sand and polish it. I think it will be nice.
This thread will move slowly, as I must complete the gray #3 first. We will be working on this when we have some spare time.
The project:
1. Disassemble vehicle, remove doors, tailgate and hatch.
2. Prep jambs.
3. Replace passenger side fender.
4. Close all holes in rocker panels from trim.
5. Remove seam sealer in roof gutters, and windshield area, repair any rust, seal again.
6. New lower door skin replacement panels, Lower tailgate replacement panel. Sand blast remaining rust, seal bare metal with POR-15, new seam sealer.
7. New quarter panels and any rusted sections of inner fenders.
8. Paint jambs and install doors, hatch and tailgate.
9. Exterior paint, B/C, wet sand, and polish.
This will be the original color also, I am excited to spray this brown color in new modern paint, wet sand and polish it. I think it will be nice.
This thread will move slowly, as I must complete the gray #3 first. We will be working on this when we have some spare time.
The project:
1. Disassemble vehicle, remove doors, tailgate and hatch.
2. Prep jambs.
3. Replace passenger side fender.
4. Close all holes in rocker panels from trim.
5. Remove seam sealer in roof gutters, and windshield area, repair any rust, seal again.
6. New lower door skin replacement panels, Lower tailgate replacement panel. Sand blast remaining rust, seal bare metal with POR-15, new seam sealer.
7. New quarter panels and any rusted sections of inner fenders.
8. Paint jambs and install doors, hatch and tailgate.
9. Exterior paint, B/C, wet sand, and polish.