Okay so I finally got around to fixing the blown bulbs on the dash. And I'm pretty sure I'm going to have to remove the dash again.....
It was tedious but not too bad, when I get to the gauge cluster I find that a few blub carriers are missing and a few are holes are covered with tape. Can anyone tell me if these are supposed to be missing? It was obvious that I wasn't the 1st in the dash as a lot of screws were missing or replaced with odd sizes and even a bolt or two.
Also my ABS light is on full time and I'm not sure if I screwed something up or if I need to get that checked and my AC/Heat controls still aren't fully lit??? Also I still dont have a check engine light which is probably one of the missing ones.
It's a 1994 no front or rear lockers. And below is a pic of the back of the gauge cluster
It was tedious but not too bad, when I get to the gauge cluster I find that a few blub carriers are missing and a few are holes are covered with tape. Can anyone tell me if these are supposed to be missing? It was obvious that I wasn't the 1st in the dash as a lot of screws were missing or replaced with odd sizes and even a bolt or two.
Also my ABS light is on full time and I'm not sure if I screwed something up or if I need to get that checked and my AC/Heat controls still aren't fully lit??? Also I still dont have a check engine light which is probably one of the missing ones.
It's a 1994 no front or rear lockers. And below is a pic of the back of the gauge cluster