So the PO had made a ton of changes to the electrical system and I am going through and fixing them.. The issue I am having right now is that I have no low beams. I am not sure what happened but I did find a burnt relay behind the right headlight and I replaced it. I also noticed some bare wires that have been soldiered but not wrapped with electrical tape or shrink wrapped. I will be re soldiering them and shrink wrapping them tomorrow.
I wasn't getting any light, hi or low beam until I replaced the relay.
Do these bulbs have a hi and low beam on one bulb or are the high beams completely different lights? I.e. Inner vs outer head lamp.
As of right now when the lights are on with the high beams on the outer most lights work. The inner lights do not work at all nor have they ever.
I do have a Haines manual but I cannot find where I left it. It may be at my parents house where I worked on it last week. But as of right now I don't know where it is. So please no snarky get a manual remarks. I have one but am just hoping someone with a little knowledge can easily tell me the answer to my question.
Thanks in advance!
I wasn't getting any light, hi or low beam until I replaced the relay.
Do these bulbs have a hi and low beam on one bulb or are the high beams completely different lights? I.e. Inner vs outer head lamp.
As of right now when the lights are on with the high beams on the outer most lights work. The inner lights do not work at all nor have they ever.
I do have a Haines manual but I cannot find where I left it. It may be at my parents house where I worked on it last week. But as of right now I don't know where it is. So please no snarky get a manual remarks. I have one but am just hoping someone with a little knowledge can easily tell me the answer to my question.
Thanks in advance!