Does my '07 look like it's had a sensor lift or is it stock? Everything I know about this truck says it should be stock but man it looks high. This was taken just after coming off the trail and starting to air up.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Torsion Bars and AHC front sensor to adjust the pressures at the front, coil springs change and AHC rear sensors to adjust the pressures at the rear. It's always a combination of both.I thought you only adjusted torsion bars for pressures.
Tries going into H mode, then goes back down to N. I think you are right about it not overpressurizing the system. Hopefully the cable I get tomorrow can read my pressures cause my current cable is not connecting to the ahc ecu in techstream (but it has worked in the past)@2006 LX470 What does the suspension do when you press the H setting? Does it attempt H and then come back down to N or does the H light flash and nothing happens?
Tries going into H mode, then goes back down to N. I think you are right about it not overpressurizing the system. Hopefully the cable I get tomorrow can read my pressures cause my current cable is not connecting to the ahc ecu in techstream (but it has worked in the past)
I cannot get to the live data for the AHC since it will not connect to the ecu. I can view live data for the engine ecu just fine thoughI had to clear the DTC’s manually (with a paperclip in the obd connector outlined in the FSM) when TS didn’t connect to the AHC ECU - although it was able to read live data (if I clicked that button - not default), but couldn’t read the trouble codes - which can be blinked out by the way (with a paperclip in the obd as per FSM)
Mine also said it wouldn’t connect to the AHC ECU, but in reality it just couldn’t connect to the trouble codes section. After aknowledging the error message and clicking on data list it however showed the sensor readings.I cannot get to the live data for the AHC since it will not connect to the ecu. I can view live data for the engine ecu just fine though