Hey ... Yep another ahc post .... last year I bought new spheres etc fitted em and cleaned the pump assembly everything was fine.
This year I decided to do my yearly ahc bleed / flush. Went well everything was OK then one day car was parked a few days and when I went to drive it suspension felt messed.
Then it went down all the way to the bump stops.
I've changed the pump assembly (the part inside the pump not entire thing with motor and tub).
I've cleared codes (pump pressure abnormal) and done active test but the thing will just not rise up.
I have felt the motor running during active test.
1. When I loosen the pipe from the motor and run it directly should the fluid come out of the motor with a lot of force? Mine seems to come out slow.
2. Trying to bleed the spheres past few days get very little or nothing from them.
3. The accumulator sometimes has a bit of pressure on the bleeder but normally when I'm trying to bleed its as if its dry.
4. My front right height control sensor seems buggered as its not changing value and it way off compared to front left and rear. Can this stop the car raising even in active test mode.
5. I always end up with pump abnormal pressure error on tis I normally have to clear this before active test will even let the pump run.
Spheres were from plaeides fitted myself were fine till recently.
This year I decided to do my yearly ahc bleed / flush. Went well everything was OK then one day car was parked a few days and when I went to drive it suspension felt messed.
Then it went down all the way to the bump stops.
I've changed the pump assembly (the part inside the pump not entire thing with motor and tub).
I've cleared codes (pump pressure abnormal) and done active test but the thing will just not rise up.
I have felt the motor running during active test.
1. When I loosen the pipe from the motor and run it directly should the fluid come out of the motor with a lot of force? Mine seems to come out slow.
2. Trying to bleed the spheres past few days get very little or nothing from them.
3. The accumulator sometimes has a bit of pressure on the bleeder but normally when I'm trying to bleed its as if its dry.
4. My front right height control sensor seems buggered as its not changing value and it way off compared to front left and rear. Can this stop the car raising even in active test mode.
5. I always end up with pump abnormal pressure error on tis I normally have to clear this before active test will even let the pump run.
Spheres were from plaeides fitted myself were fine till recently.