Pulling out an 18 Wheeler with my FJ Cruiser (1 Viewer)
- Thread starter CBPO
- Start date
-
- Tags
- fj cruiser towing
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
That is freakin' awesome.
Bravo!
- Thread starter
- #5
- Thread starter
- #6
Thanks man. I thought it was pretty cool.
The Trucker was super happy not to have to spend hundreds on a wrecker.
- Thread starter
- #7
The FJ Cruiser is a 2010 - currently it has 168k miles on it. Haven't had any real issues - changed the brakes, kept up with maintenance... That's about it.
The rear end did get a bit over pressured during this incident - I didn't notice until I started to get wheel speed sensor issues. I pulled the sensors and found that they were covered in gear oil. So I figure the hub seals had blown due to the pressure in the rear end.
I cleaned out the hubs and the sensors - reinstalled them and haven't had a problem since. Guessing it was a one time squirt by and then it must have re-sealed itself.
The rear end did get a bit over pressured during this incident - I didn't notice until I started to get wheel speed sensor issues. I pulled the sensors and found that they were covered in gear oil. So I figure the hub seals had blown due to the pressure in the rear end.
I cleaned out the hubs and the sensors - reinstalled them and haven't had a problem since. Guessing it was a one time squirt by and then it must have re-sealed itself.
///// Guessing it was a one time squirt by ///// Ive done that, bent down to touch my toes too fast and... oh wait, what.
Good story man.
Good story man.
