- Thread starter
- #41
This was a pretty straight forward install. I used ARB part #10900027. I wanted to use just the socket instead of the surface mount so I could use the factory plug hole.
I started by pulling the tailgate trim piece.
Then I popped out two of the black body hardware pieces holding the rear quarter panel on. One was to the right of the jack the second is pictured above. I then removed two 14mm bolts holding the seat belts in place. Then I removed the trim piece with a Torx set that was holding down the third row seat bracket. Once this was done the entire panel was loose and just needed to be popped out of the remaining panel clips.
I then popped both door sills on the passenger side.
I removed the front side cowl by removing the retainer bolt on top of the foot rest. Once I had this done I used a coat hanger and carefully pierced the boot going into the engine compartment. It comes out below the master cylinder.
I used the coat hanger to pull the wire from the front into the vehicle. I then ran the wire down under the carpet.
Then I popped out two of the black body hardware pieces holding the rear quarter panel on. One was to the right of the jack the second is pictured above. I then removed two 14mm bolts holding the seat belts in place. Then I removed the trim piece with a Torx set that was holding down the third row seat bracket. Once this was done the entire panel was loose and just needed to be popped out of the remaining panel clips.
I then popped both door sills on the passenger side.
I removed the front side cowl by removing the retainer bolt on top of the foot rest. Once I had this done I used a coat hanger and carefully pierced the boot going into the engine compartment. It comes out below the master cylinder.
Last edited: