Rocker panel dimensions?

[Ambrew]

Hey folks.

I'min the process of rebuilding the tub of my 81 bj42 and need new rockers. The door sill is still good so I'm hoping to fab some up. Thing is, i have no dimensions to work with since the PO has already done a home job on them.

I need the measurement along the bottom front to back and the height from the door sill. I' ll figure out the bolt holes later.

Thanks!

Andy

 

[SouthBostonFJ40]

I have a set of these that I can measure, but not until Saturday.

 

[Ambrew]

Could you tell me the measurement on the outside from the bottom lip to the top of the door sill? I need to fabricate some and what was there did not serve as a reference.

 

[Ambrew]

Specifically, I'm looking for this:

 

[Ambrew]

Anyone? I need this measurement to keep going on my project, and dont have another cruiser to compare to...

 

[doseman]

185mm on my 79 fj40-rockers are pacol manufactured, not original
hth doseman

 

[Ambrew]

Thanks! And that is from beginning of the straight part, below the door sill ? Just want to make sure!!