[iglou]

i started a post a while back asking for input about an overheating problem:
Overheato Problemo!

my father-in-law & i dug into the engine this past weekend and tore out the head for a checkup. even though the exterior seemed okay, the machinist reported back that there was an interior crack too big to be pinned. with this info, does anyone have a rebuilt or used cylinder head for a 1983 fj60? i live in glenwood springs, co 81601.
thx
iglou

[Bahndo111]

I have two 2F engines, one is missing the valve cover, the other runs pretty good. If you can give me a week or two I can pull one of them for you. They could probably both use a rebuild but if you are inclined it's not that big a deal (if you have the tools also). Let me know,
Bahndo

[fjman]

Make sure you get the correct head. When I went searching for a match to my 1986 head, I discovered that there were a number of different castings. I ended up getting a good used one from cruiserparts.net The first one they sent me did have a very fine crack in it, but they had a good one at my door within a week.
Apparently, it is very important to have matchiing casting numbers as there were slight variations...

Good luck with the rebuild. 2F heads sure do weigh a lot!

[fjman]

Originally Posted by Bahndo111

I have two 2F engines, one is missing the valve cover, the other runs pretty good. If you can give me a week or two I can pull one of them for you. They could probably both use a rebuild but if you are inclined it's not that big a deal (if you have the tools also). Let me know,
Bahndo

Where do you go to school? Ever come to a clcc meeting?

[jgordon]

Man, That'd have to be a damn nice 83 FJ60.....

[iglou]

hey fjman,

how many different castings? thousands?
where's the casting number located?

thx