These 3/16" skid plates have already been cut and drilled to mount on a 96 but I'm told that 94-97 should all be the same. These were cut with my torch so they don't have plasma smooth edges but 10 minutes with a grinder and you'll be good to go. I'm selling them cheap at $150 just to cover the cost of the metal and my oxy-acetylene (I made one for myself and had a lot of left over metal). I've tested mine repeatedly and it's stout as can be and since they stretch from frame rail to frame rail for support, I think it's impossible to bend them enough to make contact with the tranny pan.
I just drove from TX to DC and sold a couple along the way but I still have a couple left. Going overseas soon so I'm looking to get rid of them asap so I can avoid storing them.
Disclaimer: Even though I made the holes oversized for adjustabilty, slight modifications may be in order. I'm laid back and depending on when/where we meet, don't mind helping you install it.
Don't mind the green paint, it's what I had when I primered mine. If nothing else, it makes a contrast so you can see it better.
Linear Mode
