1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

V8 adapters

Discussion in '40- & 55-Series Tech' started by BetaBob, May 15, 2003.

  1. BetaBob

    BetaBob

    Messages:
    21
    Likes Received:
    0
    Joined:
    May 15, 2003
    Hi all, hey I have a question, has anyone seen or heard of a succesful fabrication of a V -8 adapter using a stock a chevy bell housing. My buddie just sent me some photos of one, looks pretty good. A couple of hot rodders just couldn't bring them selfs to buy one, so they made one.....
    I'll try and down load the shots for all to see.
     
  2. Ethan

    Ethan

    Messages:
    95
    Likes Received:
    0
    Joined:
    May 15, 2003
    Location:
    Northern California
    I know a guy who adapted a 350 to a stock 4spd using 1'' aluminum. he says he has had no problem. used the 11'' flywheel and clutch with yota slave. it helps to have a mill but can be done with a saw and a drill press. heck even a drill could pass if you take your time.