- Thread starter
- #101
Changed out the turn signal switch I picked up from woytovich. Not a hard job but can be an aggravation none the less. That detention ball in the pic goes on the end of the switch. A true pain!
transforming the dent (1 Viewer)
- Thread starter the gimpey one
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #102
Went to a 33x12.50x15 tire on American racing wheels. No idea on wheel width. Bought them used from a friend.
- Thread starter
- #103
Then immediately killed what was left of my drivers side wheel studs.
- Thread starter
- #104
Picking my hub up tomorrow from trollhole. Studs are a little short still so going to try these lug nuts from Prestigewheel.com.
- Thread starter
- #105
So I have a tie rod that needs replacing. Tried it with a pickle fork but could not get it to separate. Went and picked up this tie rod separator from autozone. Popped right out. I have a oil leak somewhere up front at the crank seal I believe. Going to have to try and fix it sooner or later.
You gonna make it to CCLR this year?
- Thread starter
- #108
Afraid not. My work schedule changed. I won't have enough vacation time for cclr and our events this year.
- Thread starter
- #109
Been a while since I have posted here. Got some leaks I need to sort out on my transfer case. Some of them are coming from behind bolts. When I reassembled years ago I didn't use any ppg or anything of the sort. There is also a leak at the output flange. Assuming I need to replace the seal. Question however! Do they make a speedi sleeve for that area as well?
