I was hoping to get some help here, the people at painless wiring blew me off even though it is their harness.
I just put TBI on my small block in the landcrusher and thing is giving me problems I can't figure out or find answere to...
It has power and sounds good until it starts to warm up, then it sounds like it is starving for fuel, no backfire though, it will start to idle down and then just die, has no power when warm.
Coolant temp sensor checks good acording to resistance readings on internet, dead on...
Fuel pressure is great, 14, dead on, always, no fluctuation.
New ignition module, plugs, wiring, cap and button, timing set according to manual, 0 deg. with brown wire unhooked.
Used a painless harness, the computer is for an auto, but the park swich is wired closed. No vehicle speed sensor, no knock sensor, no egr.
I think that everything else is wired correctly.
It will still stall when the thing gets warm with the IAC unhooked.
If anyone has any ideas, please help me...
Thank you,
I just put TBI on my small block in the landcrusher and thing is giving me problems I can't figure out or find answere to...
It has power and sounds good until it starts to warm up, then it sounds like it is starving for fuel, no backfire though, it will start to idle down and then just die, has no power when warm.
Coolant temp sensor checks good acording to resistance readings on internet, dead on...
Fuel pressure is great, 14, dead on, always, no fluctuation.
New ignition module, plugs, wiring, cap and button, timing set according to manual, 0 deg. with brown wire unhooked.
Used a painless harness, the computer is for an auto, but the park swich is wired closed. No vehicle speed sensor, no knock sensor, no egr.
I think that everything else is wired correctly.
It will still stall when the thing gets warm with the IAC unhooked.
If anyone has any ideas, please help me...
Thank you,