1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

bearing and seal kit p/n's

Discussion in '80-Series Tech' started by AZcruiser, Jun 25, 2003.

  1. AZcruiser

    AZcruiser

    Messages:
    332
    Likes Received:
    0
    Joined:
    Jun 24, 2003
    Location:
    phoenix
    I am planning to replace all four wheel bearings and probably tackle the knuckle seals too. Anyone know the Toyota p/n's for the bearings and seal kits for a 94? (semi-floating rear axel)

    Thanks
    Chris
     
  2. landtoy80

    landtoy80

    Messages:
    5,668
    Likes Received:
    241
    Joined:
    Mar 13, 2003
    Location:
    North Front Range, CO
    A better way to go is get a low mi FF rear end.You will only need seals. Then you will have a locker too.
    kurt
     
  3. AZcruiser

    AZcruiser

    Messages:
    332
    Likes Received:
    0
    Joined:
    Jun 24, 2003
    Location:
    phoenix
    Beo - amazing - especially with the 3 options. I was really surprised with the price spread between the kit vs. piece price. How about I fly you down to do the job!!

    landtoy - thats not a bad idea, I will do some searching and see what I can find.

    Thanks
    chris
     
  4. cruiserdan

    cruiserdan SupportingVendor Emeritus Supporting Vendor Moderator

    Messages:
    20,603
    Likes Received:
    2,981
    Joined:
    Mar 27, 2003
    Location:
    Surrounded by Cruisers from all over the world
    SFA bearings 90365-47013 x 2 $60.71 each list.
    SFA seals 90311-47001 x 2 $6.04 each list.
     
  5. Hltoppr

    Hltoppr SILVER Star

    Messages:
    2,020
    Media:
    4
    Likes Received:
    3
    Joined:
    Aug 29, 2002
    Location:
    Port of Indecision...otherwise Northern Arizona
    Hey AZcruiser, where are ya located in the fine copper state? BMT and I are kicking around the idea of a birf weekend sometime this summer...

    -H-
    (Flagstaff)
     
  6. AZcruiser

    AZcruiser

    Messages:
    332
    Likes Received:
    0
    Joined:
    Jun 24, 2003
    Location:
    phoenix
    Im in N. Phoenix area. Sounds like a good plan, Im a novice mechanic w/ little to no tools. Keep me posted.

    chris
     
  7. cruiserdan

    cruiserdan SupportingVendor Emeritus Supporting Vendor Moderator

    Messages:
    20,603
    Likes Received:
    2,981
    Joined:
    Mar 27, 2003
    Location:
    Surrounded by Cruisers from all over the world
    Lets think about this for a sec. H + BMT + Boddingtons + tools + lots of grease + surgical gloves = ooohhhhh, I wanna see that. ::)