I’m not understanding why you wouldn’t just wire in a pertronix and a 30 dollar pertronix coil and Be done with it.
From that point, you really only have three probable wires to Sus out.
The two BY wires from the starter and confirmed ground on the distributor.
I know throwing 150 bucks at a...
This is a 77, sorry I thought it was in my signature.
I didn’t even know there was a wire on the Master Cylinder but I will go check now. I’ll look up what the brake pressure switch does, because clearly it hasn’t been connnected 🤣
I’m guessing it triggers the warning light on the dash which I...
Pinhead, mark, Coolerman, Anyone?
I had two rogue wires , one which I have now identified as the oil pressure sensor wire with the factory connector YB or Yellow/Black.
The wire coming out of the same harness is Solid red (R) and attaches to nothing currently. A previous owner has twisted a WB...
She is all routed up. Since this picture I have reworked the fuel lines which were unacceptably routed.
Also, I couldn’t stand the current state of the intake. A little TLC mid project slowed down progress but was well worth an hour spent with Scotch brute pads.
A weekend in this position reminded me what working on cars does to your body in strange ways. A little different than mountain biking.
Cuts on arm are from previous weekends MTB race. I tagged a rock face of a cliff pretty hard.
Upon removal of the carb and studs, the project hit a small road block. Some point in the last 45 years, someone Helicoiled the intake. I had to clearance my deadline cruisers adapter (which is sweet BTW)
Redline cruisers has been fantastic in this entire process. Their brackets have been a...
Thanks. I measured it tonight. It looks like it is about 1 CM larger in diameter than the stock tank.
do you remember running a longer boot to reach around the power surge fully?
I bought a Non US spec overflow that I am going to mount on the radiator mount. The should workout great. All due...
Time to bring this thread back a bit. I changed the title because I never really liked it after all that occurred during the build.
Since 2014, i started Mountain biking…A LOT. and the truck has pretty much been garaged as I spend all free time training and racing with my wife.
I did swap a...
Sorry for the late response. You just resin pot it in and hook it up to 12 power that kicks on with the dash lights. There is a small blue capacitor that plugs into this and needs 12v. The little box has a slight hum.
Hopefully someone can help me out as well. My picture looks similar to this, but the center section is a little bit further forward. It still does not perfectly align with the forks for 3-4.
The truck drove fine, My wife had to move it while I was out of town and when she pulled into the...
Does AA provide or sell the engine mount adaptors?
Do these weld on or mount to the existing holes?
I seem to remember them being boltable and weldable but it has been some time since I researched this.
I got the one from amazon for around 260. overnighted for 79 cents with amazon prime. I am not sure how it works for you to purchase goods from US amazon.
How is the smell? do you have any of that burnt fuel smell left on you from driving and startup?
I am having a hard time deciding whether to hold out on this or go with a 2fe conversion. I am weighing the benefits of which one would give the best end result vs. most potential problems.
It...