Have you figured out what master cylinder you are going to use for this yet? The axles are from an ABS 80 series it looks like. Is there a non-ABS MC that can be run? I think the 60 series doesn't have a proportioning valve like the 62's and 80's do. Is that going to be an issue? If its...
I read the TSB and tried to buy the weight from Toyota using the Lexus part number but I may have ordered the passenger side weight that I already have. I just looked the part up online and found it at Lexus part site for the same as I paid from Toyota for the passenger side weight. I will...
For those of you that have added the driver side frame weight, is this weight the same one as the passenger side frame weight? And does anyone have a part number for it? And if the frame does not have the welded nut is there a OEM way to attach it? I'm finally starting to deal with this on my...
I'm looking for the weight on the drive side of the frame (if the cruiser has one). The steering wheel without air bag (of that's even possible). Shipped to California, thanks in advance.
Did you check your TPS? Could need adjustment or replacement. Does your distributor turn without you loosening the bolt for it? Maybe the fuel pressure regulator? I'm just throwing stuff out at this point.
I have one that was rebuilt by a Mud member and I'm in northern California Bay Area. I have no use for it and it is taking up space in my garage. It has a new OEM output shaft and I can put you in contact with the Mud member who rebuilt it if you have any questions. PM me if you are interested.
I have one in California that was rebuilt by a Mudder. It has a new OEM output shaft. PM me if you are interested. I have no problem shipping it through freight.
Hate to be a negative Nancy but it seems like a lot of work for no gain really. IMHO just buying an FJ-60 would have made more sense. I have swapped a 3FE into a 60 series so I am not afraid of these kinds of mods, but I am really not sure what you are gaining from all this work. The EFI on the...
Thanks for the response. When I put this engine together 7 years ago I suspect that I put a little too much Toyota FIPG and that caused a small oil leak. The FSM doesn't say anything about coating the gasket but I think I will put a very very think layer of FIPG just to be safe. Anyone else have...
I am installing the front end plate on my 3FE. Should I put any gasket treatment or something similar on the gasket between the block and the front end plate? I was going to use some Toyota Black FIPG but I wasn't sure if that is what is normally done. What is the best way to install the gasket...
Are you converting to 134A or are you staying R-12? Don't forget all new O-rings and get the correct ones for the refrigerant you are using. You also should replace the oil and use the correct oil for the refrigerant you go with. I stayed R-12 when I did mine and I was happy to have frigid air...
I did ask Toyota but the parts guy wasn't the normal guy I go through so I wanted to make sure he was right when he said it was NLA. If the Denso part has worked then I will go with that.