Nice build robinhood4x4.
How is the spare under tongue working for you?
Looks like the stabilizer extensions fit when folded up, or did you redo the design? I need to do similar, think I have ~4" to work with when folded up and don't think that will be enough, may need to space them down off...
Thank You Malleus, appreciate the response. I don't know the tongue weight as it's stripped to frame now.. but I figure the tongue will be ~6' beyond the front of box. I was planning on adding weight to rear in form of house batt/s and possibly water tank to lighten up tongue if needed.. not...
Hello MUD members, could use some guidance on a project.
I'm currently rebuilding a Coleman Colorado pup, some frame upgrades in addition to new suspension and axle. This trailer stock weighs in around 600lbs, I estimate maybe twice that once completed.
My question regards the material for the...
After waiting a week with no reply from abc trailer parts I called a local place.
Home | Hennessey Trailers | Levittown PA enclosed, equipment, utility, cargo and boat trailer dealer
3500# Dexter axle to custom length, flanges for brakes later, EZ lube spindles and leaf springs, hangers...
This was the setup i used to mount my RTT on my non-Cruiser..
I have 8 Thule 300 gutter mount towers, 4 have locks/key and 4 do not. 4 58" loadbars.
Two of the loadbars were older and the vinyl covering was splitting.. i cut it off except where it sits inside towers. There is absolutely no...
This engine came out of my old FJ-40 close to 18 years ago in exchange for a fresh 327 in another parts rig i bought. Been in garage since, the original owner of this Cruiser installed it after his GF wrecked the Vette.
I ran the numbers the other day to verify what i have.
Block casting...
www.armyjeepparts.com click on the Gillespie Coatings tab. They have a few different shades and a primer as well.
Sprayed it on my rig about 4 years ago.. holding up very well.