Or get replacements from Brazil:
M/C 31410-98001 Cilindro Mestre Da Embreagen 7/8"
M/C seal kit 31420-98001 Reparo Do Cilindro 7/8"
Slave 31470-98001 Cilindro Auxiliar Da Embreagem (Completo)
Slave seal kit 31460-98001 Reparo Do Cilindro...
Looking for the early 40series (63ish to 67) rear view mirror with the 3bolt mount--complete or just the mount. This is for a 67fj45, so technically the -60020 version, but I could also make the previous -60011 work.
The connector you seek is Toyota 90980-11157 (Sumitomo 6187-3901). Like half the electrical connectors on a Toyota, it is part of a wire harness assembly and generally not available separately. You might try amayama.com
Looking for an early (1980 model year and older) H41 4spd transmission. This would have a 16spl output shaft and would have been attached to a single piece t-case. Doesn't matter which input shaft (gas or diesel). The input shaft would have 22teeth and a 1st gear ratio of 4.925.
A very...
Having just dissected knuckle balls this week for a project, I can confirm that the late axles do in fact have 2 seals on the knuckle ball itself. The flange type seal that you removed is actually the outer knuckle ball seal. It is easily removed and replaced . The seal that you see lodged...
The question concerns adding width to the WMS to WMS when converting a drum front axle to disc brakes. Some of the companies selling bolt-on caliper brackets specify the increase in front axle width with their products. I am not using the add-a-bracket--I am using fj60 and/or minitruck...
I've done the searching, looked at builds, read the disc brake conversion writeups, peered over the archives, and studied my service manuals. Toyota has never published knuckle ball or knuckle dimensions/specs . The two outfits currently manufacturing knuckle balls (or bells) don't share any...
Looking for the centered rear axle from a 60-62 fj40 (not fj25). I could also use just the front or rear differential from the same. Will pay shipping to Nevada.