Thanks. No, I haven't made any calls yet. I have 3 good recommendations in addition to yours. I have another project going right that is getting all of my free time and energy. I do need to get the 80 in probably in the next 2 weeks or so.
Hey guys. It's been a while since I've been active on here. Hope all the local guys are doing well.
...like the title says, IT finally went.
After about 4 years of it being driven about 100 miles each, last year I gave the 80 to my 16 year old son to daily drive. He was pretty good about...
I can't make it June 8th, I'll be at the NOHVA ATV Jamboree in Genoa, NE that weekend.
I don't know if any of the other dates would work for me yet, so you guys do what works best for the group and I'll see if I can make it on the date you decide.
My thanks to Aaron for the email. I don't get on 'Mud but once every few months, so I was out of the loop on this (and the last Tuttle trip too, evidently).
I will be Turkey hunting in Niobrara that weekend, so I will be unable to make this trip.
I have subscribed to the thread that Grench...
I have not looked at the article, but Slee has a front diff drop bracket for the 100 series to reduce the angle a bit.
http://www.sleeoffroad.com/installation/UZJ100_diff_drop.pdf
80 series Slee adjustable front coil spacers
I purchased these last spring from a member and never installed them. Passing them on to another member for what I paid.
These are rare, cool, and very stout. From previous descriptions the center threaded section is alloy, and the rings are steel...
I could look at the Omaha vehicle for you next week, PM me if you're serious.
However, I do have personal experience with the dealer, and I'd stay away from it.
I purchased an older pickup from them last November. They puff-can undercoat and do quickie rust repairs. One can tell from the...
My office chair armrest adaptation. The padded piece is easily removed by loosening 2 screws from underneath. My plan is to create a new piece in more of the shape of a vehicle armrest and have it covered to match the seat covers.
It's adjustable up and down using the button seen on the rear...
I ran 10oz of Dynabeads in my 35s for a while. They worked well on the street, but on the highway they were sketchy. Going straight they were 'okay', however after going around a long, sweeping bend at speed, and straightening back out, the rig would begin to shake. I would have to pull over and...
I put a 'wheelskin' on my 80 4-5 years ago and it is holding up well. If you take the time and install it right, it looks very near OEM. Also makes the wheel rim a little thicker.
My wife's LX470 has the OEM wood wheel. I actually don't like it. Driving with a hand in the '12 o'clock' position...
If these guys weren't reluctant about shooting at you for driving away, there's no telling what they would have done once you gave the vehicle to them.
In that case, you fared better as a large, ambiguous target driving away then you would have as a certain, defined target standing alone on the...
So slide that extraction tool into the connector next to the terminal, pushing until you feel a good amount of resistance.
It helps to push the wire in farther while you are pushing the tool in.
Do not pull the extraction tool out before pulling the wire out. Pull the tool and the wire at the...