My rear wiper stopped suddenly in the 2 o'clock position.
I popped the switch out of the dash and checked it out with an electrical tester. I have power to the red wire, but with the vehicle on and the switch on, none of the other wires are hot.
To double check I unplugged the rear wiper motor...
The no mess way to do this is:
Before attaching and tensioning the belt-
leave the plug on the reservoir (where the ps return line connects)
Then fill the reservoir with Dexron.
Put the return line in a can to catch the Dexron overflow
Turn the pulley clockwise by hand or with a wrench if it's...
I use about 5' of clear plastic 1/2" hose. Run it from the engine bay down to the fill hole in the transmission. Looks a lot like an IV, but it was cheap, clean and effective.
thermostat housing attaches to the block above the water pump. Two VSV's screw in the side of it. I would check the hoses first but its possible the gasket failed.
I appreciate your help. A good nights sleep and a new perspective did the trick. the hang up was
the second bearing on the steering column. It is not pressed in but needs to fit into the ignition housing,
behind the spring and plastic retainer. Sorry for leaving out pictures, next time Im...
I took apart the steering column today because I was going to swap out the ignition housing.
Turns out the used part is not correct so I disassembled it again to put my old one back on. For some reason
I cant get the four short bolts that hold the tilt mechanism to the column lined up. I...
Congratulations on your beautiful rebuild. I am currently troubleshooting the same issue, coolant in the oil. I first removed the oil cooler,left a hose on each end, clamped a bolt in one end and submerged in a bucket of water, pressurized with an air pump and there were no leaks. Fixes are...