- Thread starter
- #1,501
Well today I made a in engine press to try and move the sleeves into place. I did get them to more and they are now at the maximum allowable protrusion and the are all level other than #2 the part of it next too #1 is still off a bit if I take a machines straight edge and lay it from 1-3 I can fit a .005mm feeler through. I don't think I can get it any closer than it is with out a full tear down and paying a specialist to do the sleeves.
Any ideas?
Here is my press, on e I have the bolts torqued to 100ft/lbs I then give it a few good smackes with a 3lb sledge.
Any ideas?
Here is my press, on e I have the bolts torqued to 100ft/lbs I then give it a few good smackes with a 3lb sledge.