the stig

Saving this for others in case the photo is ever deleted. Wit's End Turbo Downpipe Blanket made by PTP Turbo Blankets Part No. FPR035-188-01

No idea on cost yet. They asked for the PN and said they could reproduce since WE is gone. The DP is this: Mine is ded.

I’ll grab the number off the turbo blanket when I get a chance. Also interested in the downpipe number. Any idea what the cost on either is?

Yeah... That won't work for me lol. I might have gotten pretty liberal with trying to make it work. The gap is quite large. And it never lined up close enough anyway.

I taped mine up with HVAC tape (the shiny, metal-like tape) and drove about 14 miles (25 minutes) to get to the muffler shop. I just took it real easy and didn't have any issues. The tape kinda worked - it wasn't fully intact when I got there.

Alright everyone, I am finally to the point I am ready to fire up after install. My only hang up is my exhaust. For the life of me, I could not get the exhaust to line up with the downpipe. Am I ok to drive the car without it attached for any...

As I recall, I had to use a longer bolt to then "deform in place" the tab to fit the bracket on the bell housing. It needed to twist and flex to fit the bracket. Two pictures below. Let me know if you need different angles.

You are my hero. Answers my question of if the bracket stays flat or is bent. So did you bend it some before getting it in by chance?

Hello all, been reading everywhere and can't seem to find what I am looking for. Can someone take a picture of the bellhousing clamp/bracket set-up on their rig? For the life of me, I can't seem to make it line up in a way that fits, and my arms...