Mine is from a 1993 HDJ81. The only difference I can see is the cup holder needs to be swapped to other side. Holes, etc are already there.
Attached are some pix.
Cheers,
Greg
I just received and installed a Manta 3" stainless exhaust. Was perfect fit and easy to install. Got it from Evergreen, a US distributor. Total with shipping was $1293. Took 3 weeks to arrive.
Manta Australia
Manta Exhaust Stainless-Evergreen Off...
For those who might be curious about not running fender flares and what to do with all of the holes left behind, I've been sealing up the fender flare holes by using an old school trick: flux core solder.
For small holes (up to 1/4 inch), this...
As part of a bigger service(timing belt, water pump, all water lines, valve shims, radiator swap etc etc) I made the effort to get a pdi intercooler to fit above the factory winch. Everyone I asked said it wouldn’t fit with the winch there, but...
https://cruiserteq.com/7x-series-knuckle-rebuild-kit-01-1990-07-1999-70-series-land-cruiser-6-lug-w-manual-hubs/
A US based company, but they might be able to help with part numbers.
Also could try Partsouq-just enter the VIN...
Heya Guys, new here and was told a small show and tell is etiquette. Here is my 1995 KZJ71, pretty stoke with my first cruiser and although she’s road legal and drives well there’s a lot of work to be done. Hopefully I can rally the troops to...
You get the catch can, bracket, hose, barb fittings, and hardware. All neatly packed and shipped to your door.
If I were to order just the catch can to the lower 48 right now, it would cost me $90 shipped w/tax. Note that it's currently on sale...
Went to grab some parts for a customer from Specter Offroad. Decided to take Bacon to test out the new headers, EGR delete, Rear Heater Delete. Happy to report no leaks. Just a tad bit louder than factory, but definitely a deeper tone.
Fox Bravo Overland is planning an overland adventure heading north of Albuquerque into southern Colorado and back. We're a non-profit overland adventure group providing outdoor adventures for our deserving veterans and first responders.
We'll be...
Decided the light silver truck needed some contrast, and the chrome was blending in a little too much. Went with a graphite color to match the OEM grill and I couldn't be more excited about the look! DUKE is looking MEAN
Pic 11) attaching the filler hoses. connected to main tank.
Pic 12) Hoses ready to connect to auxiliary tank. Note the transfer line tee-ed into the main tank vent line. (not sure if that's where it's supposed to go but its easy to access.)
Pic...
It's the Frame Number- FJ800050982
Texas will let you register it, but you have to go into the county for registration and renewal as the computer shows it is not a proper VIN.
And you have the 3FE motor...and A440 transmission, if they are...
You can use the the rear flare bed seal from 2nd gen tacoma ( 05-15). You need 4 seals total. The Tacoma one is a little bit longer so need to cut it to fit.
PN 90987-01003. I bit the bullet and went through my local dealer because the one on eBay were confusing on the part numbers and images they showed. This one did the trick.