bluehawk

Back to the drawing board. I made my radio pigtail too short and I accidentally pulled a few wires out of the plug as I was tracking down the reason for losing power to my trailer brake controller. At least I can reroute a few other wires that I...

Sweet!!!

May be open to some serious offers

If you are in VA look up @vbvagearhead . One hell of a Cruiser/Toyota mechanic

I will probably continue the build thread with the new chassis. Hope I can get the rolling chassis sold soon

I think that you should carry this project forward, Paul. It would look sweet under an FJ45 extended cab with a bobbed truck bed.

Weekly bump

GLWS Solid platform! Nik

That’s what I have in it money wise

I posted it in the classifieds. Thread 'Knoxville, TN Stretched FJ40 Rolling Chassis' For Sale - Knoxville, TN Stretched FJ40 Rolling Chassis - https://forum.ih8mud.com/threads/knoxville-tn-stretched-fj40-rolling-chassis.1334135/

Good deal. Do you need an 80 rolling chassis? I have one in Oklahoma City but I’m going to Gatlinburg, TN in a week…I could always throw it on a trailer and bring it to you haha

What year model is yours Bripars40? Does it have motor, trans, tcase, and axles?

I’ve got a friend that has a 97 model that was in a roll over. It’s a complete truck. Waiting to hear back from him.

To be honest, I lost interest in the current state of the project. Keeping the stretched body and plan on putting it on a Fj80 rolling chassis

I’ve decide to go with a different direction on my 40 build. Selling the rolling chassis as is. I will not part it out. Here are the details: - 1973 Fj40 chassis stretched 12” - one ton axles from a Ford F-350 with trusses and high steer on front...

Going a different route on the 40 project. Anyone interested in a rolling chassis minus the coil overs

Not a whole lot going on with the build. I have't worked on ole lockjaw in about five months. Had a lot of other things going on. My sons 92 Toyota pickup had a blown headgasket and the head had a crack in it. My daughters VW Tiguan need a ton of...

What’s new with this build?

You probably already solved it but I’ve put roughly a 5 degree bend in all the front pan hard bars I’ve done, just to clear the differential cover. Chock it up in a tube bender and give it a little push