These frames are so hard to get a nice clean weld on . I am far from a professional welder but for whatever reason the frames just are hard to get a clean weld . I don’t think it will fall apart but I want it to look good
DANG MAN! See, it's post like above as to why I don't have a loaded savings account!!!!!
@TuckerHudson FWIW - I've run the Sniper since 1/2020 ..... did have an ECM issue in 10/2020, but Holley quickly replaced my unit free of charge. About...
I ran a variety of springs underneath what is now my dedicated trail '40. Factory springs, a set of the old aftermarket 3 leaf "kidney busters", a set of Pro Comps and a set of OME all in SUA configuration. Once I went SOA, I tried OEM FJ40...
In case you wonder, I am going to totally plagiarize @Tank5 's front bumper.
https://forum.ih8mud.com/threads/the-milk-truck-fj45-preservation-sorta.1172484/page-12#post-13753286
Thanks to @kc_chevota Got the engine back in, waiting on a new fan bearing part Aisin FBT 002 -- so started working on all the different things. I had a wiring harness that @Tank5 had given me years ago, stripped it back to find three separate...
depending upon ur end goals, like lug count and spacing, there are some junk yard axles one can cut the ends off the axle housing and reuse to get factory disc brakes, e-brake, etc and save a lot of $ (assuming u probably already know said) and...
Done. Now I just need to tape those wires around the positive terminal and run them straight to the engine harness without any fuses and it should be good to go.
I got this battery tray from Ruffstuff three years ago and it was the first fab...