Montana Cruiser

Stock coil springs off my 80 Series Land Cruiser, Front and Rear. Good shape, but I went with a lift. Located in Reno, NV. Must pick up, no shipping. FREE Also have some KYB Gas Adjust Shocks (front) with about 1000 miles on them, and OEM...

☝️ 💯 And don't let ur wife know 😎

Driving from Carson City (Reno) over I-80 to Manteca was glorious with some @Cruisers and Co forced induction. Our group set out at 0500 this morning and didn't look back. Set the cruise at 70-75 and let it eat all the way up the hill. Never...

Hung out with valley hybrid and Terrain Tamer swap meet. Also saw C&C in the wild! @reklund5

I agree. For those like myself who want to run the stock 16" wheels and oversize a bit to 33" and 35" OD tires, the selection is often limited and mostly E load tires from what I found.

Ride quality/comfort has as much to do with tires as it does with springs and shocks. Tire load rating and pressures should not be overlooked.

I have not installed yet, but I can confirm that those are the part #'s (shocks and springs) I have in the a garage as a "stock height" replacement. I am expecting approximately 1" over stock per a few different threads here on Mud.

Please check DM.

Awesome, can't wait to hear what you think!

We’ll find out soon…I have my trans waiting in storage for the swap components to be ready…secret $$ pocket is getting warmer everyday just itching to burn through! ;) 🍺🔧🦀

And I here I thought I was the only one. I used 1/8 steel and formed it to profile the battery box. Attached with rivets and JB Weld. Has held up for 10 years now.

I'm checking under the seat cushions of the couch to make this happen .... I would love to know how it performs behind a stock drivetrain.

A little over a month of real driving with the transmission in. Rolled over the 2500 mile mark this morning on the way to the shop. Still running amazing and can't wait to get this out there to you guys. Offroad - it absolutely crushed it in...

I think the one you have pictured is this one in the link below https://nyxfab.com/products/custom-toyota-land-cruiser-fj80-center-console-padded-armrest-dual-cup-holders-gray-beige-taupe-options

I have these, nice quality and made in Japan just like your Cruiser 😎

You can't just drop in here saying all that and not post some pics man.

I drive my "Black Hole" today up to see @lelandEOD and back home. About 90 miles round trip, with some pretty good grades to negotiate. The @Cruisers and Co turbo and intercooler make it such a fun truck to drive, especially at highway speeds...

Yes the rear crossmember leaves the chat… welding would be required to reverse Hopefully we see how it fits by replacing a certain someone’s 4x4 labs soon 😉 Also would like to say I have had a 4x4 labs for 12 years on my 80. Amazing bumper...

We didn't do anything to the outside other than some wax . there are a few rust bubbles on the bottom of the rear doors and the rear bottom of the 1/4 panels are wasted. we cut out the rust and sealed it . Because the bummer side wings cover it...

Will this new rear bumper require any cutting of the frame or anything that is not reversible? Any approximate dates on availability?

Halo ring looks pretty good I think.

Bit the bullet and had my steering box rebuilt. Nothing better than torquing your pitman arm to spec and the cotter pin lines up no problem.

Cancer survivor. Does not give a flying fũck anymore and wants a rad truck to enjoy. Smart man. It’s all just made up anyway.

PM'd you!