Spotted a clean white 200 series with a lift and ARB bumpers front and rear on Higley and Houston in the Gilbert/Mesa area. The brake lights and signals were wired up wrong, they hit the brakes and the amber lights in the bumper illuminated...
You're missing the heater valve that mounts to the firewall behind the harness. That "cable looking thing" is the control cable that opens and closes the valve.
All of those knucklehead installed hoses should be replaced. @LandCruiserPhil...
One thing to note about LT type tires is they hold up better to airing down than standard load tires. Slow rock crawling is not the issue. It’s when you’re traveling 25 to maybe even 50 miles an hour on washboard type roads when you’re aired...
Those wheels look alike but they are NOT the same thing.
Cruiser wheels have hardened steel inserts for the studs and they use conical-seat lug nuts.
4Runner/truck wheels have a square bore and use shank nuts with captive washers.
Heavy-duty...
2014 Gx460
Located in Prescott
- Clean title— no liens, no accidents
- No rust (southwest ownership)
- 4.6l V8
- 4x4 with center diff lock, DAC, low range
- 2 owners
- Private seller
- Good service history since new
- 130,130 miles
- Claret Mica...
Here is what I ended up doing to bring power to the trunk:
I first bought the 80 series cable upgrade kit from @Fourrunner; and when I did that I also asked Mark to make me a custom 8AWG cable. One section of that cable is ~13” that goes from...
Thought I would share some life updates 😎
My daughter has been living in Europe for the last 5 years.
She’s has been trying to get us to visit for a while now.
We finally jumped the pond ( long flight 😳 )
Landing in Frankfurt then jumped a train...
Landcruiserphil is spot on - this needs to be tightened, along with all of the other bolts/nuts while the vehicle is being supported by the axle housing or sitting on the tires on the ground. Otherwise, you're pre-loading those bushings now, and...
The why - The link bushing are encapsulated, when the suspension cycles the rubber is the only moving part. Torque your link anchor bolts with suspension hanging and drop it to ride height your bushing rubber is now under tension giving you a...