gifu

Bump.

Not sure who built this. It’s pretty stout. Bolts to frame. holds two water/fuel cans, tire, highlift. Located in Truckee, CA Can ship on your dime. Or deliver to Bay Area. Asking $1900 obo

This one has power brakes that are recently redone. It does not have power steering. I believe it does not have a heater either. It’s hard to say about the picture… it could be an optical illusion, or it could be that it has 40-year-old springs.

Bump. Updated pics showing non widow maker wheels. Price drop to 22,000

I’ll ship it there… then come out and kite.

This is your Cruiser Conscience speaking… you need this. It’s an amazing drivetrain. You’ll never regret buying it. But you will regret driving a mediocre powered Cruiser the rest of your life.

ARB front bumper for 80. Winch not included. Straight but has a nice patina. $600 obo

80 series rear double swing bumper. Double Gaskin on one side and tire carrier on the other. Not sure who built this it was on the truck when I bought it. It had some goofy latches that were replaced with a 4x4Labs más macho latch. It’s a pretty...

-15BFT with less than 100k miles -H55f and splitcase freshly rebuilt (Valley Hybrid) with correct 3B input and BJ60 style Bellhousing -flywheel and clutch included -correct oil pan, pickup tube, and dipstick for use in a Land Cruiser -12volt...

After searching the globe for a year this was the only new HZJ 79-series gauge cluster I could get my hands on. VDJ & GR clusters won’t work 100% with an FTE. Well, that’s just not good enough for our build, we only have one tank and we want...

Hey Bjorn, had a few questions. PM-d you.

Both fully restored run and drive

if you are swapping a manual transmission drivetrain (thank you baby Jesus; because automatics are gross) into your 80 series… you need this factory spring assist clutch pedal. (You can reuse your brake pedal; cut it down to match). $250 each...

I have a couple diesel clusters for 80 series. If you are swapping a factory 1HZ/1HDT you need this for the tachometer. $250 each

I have a Bellhousing for 1HZ/1HDT/1HDFT to H150/151/152 Asking $500 plus shipping. Brand new never mounted. Does not have clutch fork or ball. (Fork in picture NOT included)

Alberto you sell stuff too cheap. 😳

It’s still available

Interested

diesel motors may idle cooler. But will generate more heat than gas under load. I would upgrade the clutch fluid. You have to add triple stacked hood risers.