Squash

Call Dan or Steve at 4wheelauto in Edmonton, Alberta.

There are definitely two different belts. Changed belts on the hdt, hd-ft and hz. The early 1hz 75 seris and 1hdt probably share the same belts whilst the 1HD-FT and 1hz in the 79 series are comparable if I were to guess. Check...... 94 teeth...

Bad ground, loose terminals, missed connection. Good luck. Conversely get under the unit and tap solenoid starter wire with a jumper to Positive starter feed wire from battery. If she turns over then work both ways.

OK That or an online fuel shut off valve/solenoid to cut fuel before the IP....

If you are having an issue find a quiet spot. Open the hood and power up the ignition. You should hear definite a click, or clicking if you turn the key on and off. You can alternatively run a line from a POS battery post to the top of your...

A little Monday update. after putting the clear lines back on, i noticed something. i made sure all clamps were as tight as possible to eliminate any air leaks, and after sitting overnight, the clear hoses were collapsed, but with no air in them...

That's going to turn your ECU into a meth addict. Best in an old tractor engine without an ECU. My 1HZ....

I came back from shopping, parked the truck and pulled the engine cut off knob and.... nada! Turns out that the cable broke just behind the pull knob. So I checked the EPC to figure out which components were there and how it fits together...

Lost the high speed blower over the winter. All other speeds worked. After ripping through the normal suspects, I put her back together and ordered part# 061700-1200. Common part to Toyota's Just finished the swap and all is good. Lives behind...

It will bolt up and is interchangeable.

Get a convection heater 1500 watts. Pulls from your block drain 14mm socket. Cut hose to heater valve on firewall, insert a "Y" fitting and you are done. Have them on all of my units, unless it's a Webasto. Kits normally come with all...

Been a while. Climb under the unit and tap the main starter feed from battery with the solenoid. Use a sout wire or two screwdrivers to fire up the starter being careful with the screwdrivers that you do not touch metal. This tells you that it's...

Recently swapped a new HZJ79 alternator into my 1995 HDJ80. Direct fit plug and all.

Somebody else will chime in here shortly I'm sure, but the first thing I'd do to eliminate the source of the friction - disconnect the throttle cable from the lever on your injection pump. If you pull it all the way over on its spring, there is a...

Just in case. There should be a hand throttle, make certain that this is not your issue.

It's not a screw it's a linkage rod. Do yourself a favor go in the resources section of the site and download a service manual.

Lost the high speed fan, that said the lower settings all function. Ripped into the dash, and randomly tested what i could such as ds relay, 40amp fuse. Have a spare fan and both fans operate identically. Resistor on top of box seems OK, but this...

Clean that up a bit, and all shall be revealed. Make certain to torque the nut to specs once you button her up.

As some keen observers here have figured out, I bought Joe’s Troopy. Joe dropped it off Sunday night at the hotel I was staying at. Plan is to drive to Fit Garage in Bend, OR to cut the roof off and install a alu-cab pop top. Left Monday morning...

So…. I assume you have another $30k hidden away to fix your truck. 🤣🤣