MikePL

@filly do you have pics of yours?

And now who do I believe? :rofl::rofl::rofl:

Thanks but I am not sure if just looking at it will do the trick. The front output shaft is wuite long so there needs to be forward clearance in order to slide out the entire cone. There is probably some sort of selector fork over there and the...

I need to replace the front shaft output bearing. I see that the front 'cone' seems removable. I dropped the transfer case once, exactly 20 years ago and I don't feel like doing it again, now that I'm 20 years older. I know that to replace the...

I have a slightly dented hood but I don't want to repair it. I'd rather buy a cheap non-dented hood and rattle-can it. Want to buy only in San Diego county and Orange county.

Shocks are like shoes. They are different depending on application. If you ask a woman about open-budget best shoes she might say Louboutin. Ask a runner and he will say Nike. A hiker might say Timberland. What are you planning to do? That's the...

Some Big Sur camping. But also bought a new alternator, Sequoia 150A.

The sunroof gasket is meant to let a bit of water pass through. If you have a leak, the drain tubes will be the problem. Use compressed air to clean all of the tubes and the problem will be gone.

Oh and I also raised the other end of the LPSV arm by around 2in before bleeding because my suspension was lifted by the previous owner but the valve seemed to be at its lowest point on the threads.

I have a trip in 2 days so I've decided to change my pitch-black brake fluid (and slightly squishy pedal). It hasn't probably been changed since Bush was president. I bleed one wheel until clear fluid comes ou, then the second, then the third...

No, gas V6.

This is my friend's 2001 Mitsubishi Montero. All my life I've been super lucky to have vehicles without any engine problems, so while I know all the technicalities of engines, I lack 'ear-experience' when it comes to inentifying suspicious engine...

Was kinda bored today so now I have an external shower outlet... water from a taillight...it's magic.

Brand new 5.29 Yukon gears. As I look at ZUKs website I see that he favors a deep pattern, close to the root of the tooth. Kinda looks similar to ours but we wanted to be sure.

This is the rear diff. We are getting the following ring gear pattern. Of course the pattern doesn't look like anything we have in the drawings, hahaa. Backlash within spec, pinion preload within spec. 1. Do we leave as is? 2. Do we remove a...