The main issue is the heat of the engine bay. We have tried filaments that can be done with a Bambu printer that has the highest temp ratings and they do not survive. Up to about 230 degrees all is ok, but once you exceed 250 then they start...
We have a new cover designed. The issue now is trying to get a cost effective way to manufacture them. The reason we stopped the previous run was that they would have had to sell for $130 per cover using the previous method of doing them. We are...
sleeoffroad replied to the thread What have you done to your 100 Series this week?.The main issue is the heat of the engine bay. We have tried filaments that can be done with a Bambu printer that has the highest temp ratings and they do not survive. Up to about 230 degrees all is ok, but once you exceed 250 then they start...