||| Official YT For Sale/Trade/Wanted Thread |||

[vfrer]

Since some of you are into parting out 80's now.... would anyone happen to have a spare rear wiper control module available? It is located in the upper gate. I had some funky electrical things going on that I have traced back to a couple of blown diodes inside this module. I think it is the same for all years but the part number on mine is 85940-60020. Expensive little sucker.

Thanks!
Eric

[KLF]

Originally Posted by nat88toy

pics of stuff for sale

Might be interested in the snorkle, if it's complete. How much?

[Tarkus70]

Originally Posted by rabid

What are you looking for?

I am putting my truck back together I need a front winch bumper seats, non stock roll bar things like that.

[nat88toy]

Originally Posted by KLF

Might be interested in the snorkle, if it's complete. How much?

paid 330 would like to get $260 i have the template for it too you would just have to by some nut serts for the window pillar also have the hole saw and will help you install it to

[Hypoid]

Wanted; magnetic drill press, under 50lbs, under $200

[thepinktaco]

Looking for a decent tub for a 75. I have a cowl and rear tub that need work but if I can find a decent complete tub it would save me alot of body work time.

[Leaping Deer]

Wanted: FJ40 rear axle with ebrake on the axle.

[green40]

Wanted- More money so I can finish my junk.

[SouthBostonFJ]

Just a heads up, I am picking up two trailer loads full of parts this week. Probably something for everyone...
Four 33x10.5x15 Swampers, carbs, assorted body parts, 3 sets of doors, two hard tops, jump seats, front seats, custom roll bar, two sets of drum axles and more.

[jsaltlick]

Pics of the swampers for the 70?? (tires only!)

[SouthBostonFJ]

Originally Posted by jsaltlick

Pics of the swampers for the 70?? (tires only!)

I will. They have zero miles.

[remy1974]

Originally Posted by nat88toy

are you referring to the super swamper's or the buck shot mudders?
the super swamper's are still for sale $1,200 for all 5 mounted on Toyota factory 15" rims

Originally Posted by HeavyMetalViking

Good point, sorry if I responded a little quick, remy I was selling the 275/85/R15 Buckshot Mudders if they're the ones you were interested in.

sorry for the confusion and the long delay to reply was interested in the buckshot mudders.

[SouthBostonFJ]

Originally Posted by jsaltlick

Pics of the swampers for the 70?? (tires only!)

Originally Posted by SouthBostonFJ

I will. They have zero miles.

Here they are. Notice the little nubs on the tread. Rims are for sale too.

[SouthBostonFJ]

Originally Posted by SouthBostonFJ

Just a heads up, I am picking up two trailer loads full of parts this week. Probably something for everyone...
Four 33x10.5x15 Swampers, carbs, assorted body parts, 3 sets of doors, two hard tops, jump seats, front seats, custom roll bar, two sets of drum axles and more.

I never got the parts. I went to get them and they were not in the condition that the seller described or showed in pictures.
Also, the tires were 12.5' not 10.5". I wasted 4 hours...boo.

[VTCruiser]

tires for sale (still): http://forum.ih8mud.com/sale-tires-w...alloys-vt.html

also on craigslist: 33" BFG MTs on black 15x8 Alloys (toyota/chevy 6 lug)

[Leaping Deer]

Originally Posted by SouthBostonFJ

I never got the parts. I went to get them and they were not in the condition that the seller described or showed in pictures.
Also, the tires were 12.5' not 10.5". I wasted 4 hours...boo.

I spoke with the guy and he was supposed to send be pictures and didn't so I never followed up. Glad I didn't waste my time.

[82cruiser]

Looking for a good motor for a friend's '95 80 series.

Thanks!

[Impreza]

Originally Posted by 82cruiser

Looking for a good motor for a friend's '95 80 series.

Thanks!

I saw this on CL, maybe you can just the take motor then part the rest? Unfortunately unlocked.

1994 Toyota Land Cruiser

[Dr Custom Werx]

For Sale: i have a Land Cruiser Solutions one piece fiberglass nose for a 40. not cracked but paint has a few chips. they are $900 new, i want $500.

[JohnnyC]

a friend is selling his 1953 Willys Wagon:

http://forum.ih8mud.com/vehicles-tra...ml#post4380615

[landtank]

Originally Posted by Impreza

I saw this on CL, maybe you can just the take motor then part the rest? Unfortunately unlocked.

1994 Toyota Land Cruiser

There is a bit of work to get a 93/94 engine to work with a 95+ truck. It can be done though.

[landtank]

Originally Posted by 82cruiser

Looking for a good motor for a friend's '95 80 series.

Thanks!

What is wrong with the original motor?

[Hypoid]

Minitruck parts including $75 live front axle

Parting out 84 toyo 4x4 tranny,transfer etc

I'd buy it just 'cause, but it's far to go. I'm sure if someone wanted to go get it we could work an equitable trade for your time.

[82cruiser]

Quote:
Originally Posted by 82cruiser
Looking for a good motor for a friend's '95 80 series.

Thanks!

I saw this on CL, maybe you can just the take motor then part the rest? Unfortunately unlocked.

1994 Toyota Land Cruiser

Thanks for the link Impreza.

Originally posted by landtank
What is wrong with the original motor?

Not exactly sure at this point, but is related to the head. The 80 is at Wally's now so we'll know soon. Apparently, a dealer in VT had it for a while and could not fix it. It was overheating and started blowing smoke, which is why he took it in. Probably HG or cracked head. Dealer replaced the lower rad hose which promptly blew off 2 miles after he left the dealership, and they didn't know what was causing it.

[landtank]

sounds like a typical HG, no need to start looking for a new engine.

[82cruiser]

Hopefully you're right. I got all this second hand and something was said about "ugly engine noises", whatever that means. The fact that the dealer had no idea what was wrong is puzzling.

[landtank]

Originally Posted by 82cruiser

Hopefully you're right. I got all this second hand and something was said about "ugly engine noises", whatever that means. The fact that the dealer had no idea what was wrong is puzzling.

Dealers are pretty clueless.

Nat went back to the dealer where we got that red 80 from and talked with the service guy. Seems after two mechanics and a third master mechanic who logged in 8 hours of trouble shooting, they determined the truck unrepairable.

Two hours of our time produced a repaired, perfectly running 80.

[Gus]

I'm trying to clean up a bit so the following needs to go, make an offer if you aren't happy with the asking pric. This stuff is located at my place in Orange, NH or in storage in Tinmouth, VT.
Complete bust very rusty FJ60 rear axle out of an 87, $50
Front axle shafts from 87 FJ60 $20
3rd member from front of 87 FJ60, $30
Drivers side rear door from an white 85 FJ60, one scratch that has surface rust, this rig was from CO/UT so good shape, $50
4:11 course spline 3rd member from 74ish FJ40, $50

I can get pics of this stuff, pm or email with any questions.

[VTCruiser]

I'm looking for:

• a 255/85-16 mud tire for a spare. A BFG M/T would be a plus to match my other tires. Must hold air!
• a good used front driveshaft, with no play in the slip yoke!
• perhaps a rear drive shaft as well...

[jsaltlick]

I have a 60 series PS pump and a 40 series aluminum radiator I'd like to sell.

Also still have that pile of split rims.

Just remembered I have a brand new gray front PVC mat for a 60 series.